Eclipse Lighting
(847) 260-0336
Three ways to search

Titan 3 (TI3)

• BACKPLATE — 16 Ga. aluminum (AL).
• BACKBOX — 16 Ga. aluminum (AL) with wire access on four sides and back through 7/8” dia. KO flattened water tight (Optional for surface conduit entry or standard with emergency battery).
• DIFFUSER — White translucent, fully enclosed non-yellowing 100% virgin acrylic, .125 Thick (1/8”). Clear top and bottom for uplight/downlight is Standard. Optional Opaque Top (OQT) for no uplight or Opaque Bottom (OQB) for no downlight.
• DRIVER — Universal Volt (120-277v) Electronic Driver with 0-10V dimming.
• FASTENERS — Stainless steel tamperproof screws —(2) To secure lens in place.
• FINISH — Corrosion and Weather resistant, extremely durable pre-treated oven baked polyester powder.
• GASKETING — High Temp., non-aging black EPDM and/or neoprene rubber around the entire lens perimeter &
rear wire entrance hole to protect against dust, moisture & outside contaminants.
• MOUNTING — Use (4) or (6) 5/16” diameter holes for 1/4” diameter bolts for outdoor or indoor. 7/8” KO in Center for Wire Access. Must de-rate lamping for horizontal.
• SHIELD: Solid Aluminum Opaque Shield with Center Square Window.
• WALL WASH — CTB is Standard with Uplight and/or Downlight.
• COMPLIANCE — Built to comply with U.S. and Canadian safety standards. Suitable for wet locations

Cutsheets / IES


This fixture is approved for installations of the following types.

Suitable Conditions:

Dry  Damp  Wet
Eclipse Lighting
© 2024 Eclipse Lighting Inc.™ All Rights Reserved. Designs Protected by Copyright
Join us on Facebook! Follow us on Twitter! See our Pinterest page!